OVERHEAD CRANE OPERATOR CERTIFICATION  

BRITISH COLUMBIA (RIGGING & INSPECTION)

8 Hour On-Site Course 

Course includes legislation, identification of cranes and their components, pre-, mid- and post-operational requirements, general rigging requirements and rigging inspection. Exceeds CSA B167-16 standards for Crane Operation. 

*OVERHEAD CRANE OPERATOR CERTIFICATE (RIGGING & INSPECTION) INCLUDED*

12 Hour On-Site Course 

Same elements as the 8 Hour course with addition of site specific training and responsibilities including high risk rigging calculations and procedures.

*OVERHEAD CRANE OPERATOR CERTIFICATE (ADVANCED RIGGING & INSPECTION) INCLUDED.*

OVERHEAD CRANE & HOIST OPERATOR CERTIFICATION

ALBERTA (RIGGING & INSPECTION) 

4 Hour On-Site Course 

Required for Overhead Crane & Hoists under 2000KG/2.2TONS

Provincial and federal regulations, jib, bridge, grantry crane components, chain & wire rope hoist systems, pre-, mid-, and post-operational requirements, general rigging requirements. 

*OVERHEAD CRANE OPERATOR CERTIFICATE (RIGGING & INSPECTION) INCLUDED*

8 Hour On-Site Course

Required for Overhead Crane & Hoists under 5000KG/5.5TONS

Includes legislation, identification of cranes and their components, pre-, mid-, and post -operational requirements, general rigging requirements, rigging inspection. Exceeds CSA B167-16 standards for crane operation. 

*OVERHEAD CRANE OPERATOR CERTIFICATE (RIGGING & INSPECTION) INCLUDED*

12 Hour On-Site Course

Required for Overhead Crane & Hoists over 5000KG/5.5TONS

Same elements as the 8 hour course with the additon of site specific training and responsibilities including high risk rigging calculation and procedures in an Advanced Rigging Operator Certification. 

*OVERHEAD CRANE & HOIST OPERATOR CERTIFICATE (ADVANCED RIGGING & INSPECTION) INCLUDED*

OVERHEAD CRANE OPERATOR CERTIFICATION  

SASKATCHEWAN (RIGGING & INSPECTION)

12 Hour On-Site Course 

Includes Legislation, identification of crane and theur components, pre-, mid-, and post-operational requirements, critical lift procedures and lift planning, general operational requirements, rigging inspection, hand signals, emergency procedures. Exceeds CSA B167-16 Standards for Crane Operation, site specific training and responsibilities including high risk rigging calculations and procedures. 28-Hour Operator log sheets provided & completion required as per Saskatchewan Occupational Health & Saety 0-1.1 REG1 TABLE 16 (Clause 204 (1)(a) II. 

CCT is the only provider in Saskatchewan capable to provide a 12-Hour Overhead Crane & Hoist Operator Certification & release OHS Saskatchewan approved hour logs to employers for the operators to complete the remaining

28HRS of practical operations.

40 Hour On-Site Course 

This covers the same elements of the 12-hour course with the addition of extensive site-specific training and responsibilities. High risk rigging calculations and procedures are explained. The operators will have additional on-site practical training and be provided an evaluation of their skills. Advanced rigging procedures and planning etc. is included in this program. 

All Applicable taxes are extra 

Mileage $1.15/km if applicable 

Travel expenses (cost plus 15%) are extra if applicable.